A 3D printed skull shaped place card holders (for wedding names / party / event seating) made with plastic PLA filament. There is a support at the rear to help keep the card in place.
These are NOT metal. Photos of other stands used are just examples of colour options available.
Dimensions:
Height - 5 cm (50 mm)
Width - 3 cm (30 mm)
The Skull shape is 5 cm tall by 3 cm wide. Base size 2.4 cm by 3.4 cm (approximately). You can see the lines of the filament up close - Please see photos for details.
***For indoor use. Will most likely fall over / overbalance and fall over due to winds and weather outside. ***
Please ask if you would rather have in a different colour - most other colours available on request. (photos of other colours to follow - Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours).
This is for the holder only - the cards are just for display purposes. The cards used in the photos are 5.5 inches by 8 inches and 5.75 inches by 8.25 inches (15 cm by 21 cm). I would not suggest using larger card then this as they may over balance.
This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.
**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."***
