A 3D printed Large Music Note Wedding Place Holder (for wedding tables / party and event seating) made with plastic PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."
Dimensions:
Height - 7 cm (70 mm)
Width - 3.5 cm (35 mm)
The stand is 7 cm height by 3.5 cm width (70 mm by 35 mm / 2.75 inches by 1.4 inches approx) and is 3 mm thick (across widest points) and the base is 3 mm thick and 3.5 cm by 3 cm in area size. There are two prongs at the rear that holds the card in place. Not suitable for events outside as they will blow over.
The front of the holders have a smooth finish. The holder works better with card that is under 7.5 inches in height. These are NOT metal.
This is for the holder only - the cards are for display purposes. The card used in the photos is sized 5.75 inches width by 8.25 inches height and is 200gsm, (15 cm / 150 mm by 21 cm / 210 mm). Please see photos for details. (Please Note - Actual colours may vary. This is due to the fact that every computer monitor has a different capability to display colours and that everyone sees these colours)
This is not a toy and cannot be placed in a dishwasher. Hand wash and wipe clean only.
**The material is PLA filament. "PLA plastic or polylactic acid is a vegetable-based plastic material, which commonly uses cornstarch as a raw material. It is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials."*** These are NOT metal. Photos of other stands used are just examples of colour options available.
